Ämnesområden

This part of ISO 1268 specifies the general principles and procedures for the compression moulding of test plates from two types of fibre-reinforced thermosetting moulding compound: sheet moulding compound (SMC) and bulk moulding compound (BMC). The aim of this part of ISO 1268 is to ensure the preparation of flat test plates from which test specimens can be cut (for the relevant test methods, see Annex A). The plates are produced in such a way that specimens cut from them give representative results when used in these test methods.

This document outlines the concepts and principles for information management at a stage of maturity described as "building information modelling (BIM) according to the ISO 19650 series". This document provides recommendations for a framework to manage information including exchanging, recording, versioning and organizing for all actors. This document is applicable to the whole life cycle of any built asset, including strategic planning, initial design, engineering, development, documentation and construction, day-to-day operation, maintenance, refurbishment, repair and end-of-life. This document can be adapted to assets or projects of any scale and complexity, so as not to hamper the flexibility and versatility that characterize the large range of potential procurement strategies and so as to address the cost of implementing this document.

This document specifies requirements for information management, in the form of a management process, within the context of the delivery phase of assets and the exchanges of information within it, using building information modelling. This document can be applied to all types of assets and by all types and sizes of organizations, regardless of the chosen procurement strategy.

This document specifies how to perform hardness measurements at other then surrounding or standard laboratory temperatures. This procedure is ment for measurements at lower temperatures as well as those at elevated temperatures.

In the annex a test based on hardness measurements for determining the progressive stiffening of rubber with time, caused by crystallization is given.

This standard applies to lidars installed on road vehicles to measure or detect the surroundings of the vehicle. This standard applies to lidars used on all types of road vehicles regardless of vehicle classifications, including passenger cars, buses, commercial vehicles, trailers, etc. This standard describes a series of test methods to assist in evaluating the performance of lidars. The tests should cover the following: 1. The common performance specifications (e.g. Range capability, Range precision). 2. The common performance characteristics (e.g. Anti-interference, Ghost points). 3. Possible alteration of performance test caused by environmental conditions. 4. Lidar performance for the union of both ADAS/AD application scenarios. This standard does not address test methods for reliability, functional safety, and cybersecurity. Note: The definition of “Road Vehicles” includes M1~M3, N1~N3, and L6~L7 according to consolidated resolution on the construction of vehicles (R.E.3).