Yttre transportsystem för vatten

Kommittébeteckning: SIS/TK 156 (Plast)
Källa: ISO
Svarsdatum: den 24 jun 2019
Se merSe mindre
 

This International Standard establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this International Standard specifies three butt fusion jointing procedures for PE pipes and fittings. These are:

 single low-pressure fusion jointing procedure;

 dual low-pressure fusion jointing procedure;

 single high-pressure fusion jointing procedure.

This International Standard takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It may be applied in conjunction with appropriate national regulations and standards.

NOTE 1 The references for these procedures are given in the bibliography[1][2][3][4]. Single low-pressure fusion jointing procedure is derived from multiple procedures and agreed by experts, given in the bibliography [1][2].

NOTE 2 The three procedures detailed in this standard are based on those most commonly used. It is not the intention that one or more of these procedures should be used to replace well established and verified industry based procedures.

Kommittébeteckning: SIS/TK 156 (Plast)
Källa: ISO
Svarsdatum: den 27 aug 2019
Se merSe mindre
 

This document, in conjunction with ISO 11298-1, specifies requirements and test methods for cured-in-place pipes and fittings used for the renovation of water supply networks which transport water intended for human consumption, including raw water intake pipelines.

It applies to independent (fully structural, class A) and interactive (semi structural, class B) pressure pipe liners, as defined in ISO 11295, which do not rely on adhesion to the existing pipeline. It applies to the use of various thermosetting resin systems, in combination with compatible fibrous carrier materials, reinforcement, and other process-related plastics components (see 5.1).

It does not include requirements or test methods for resistance to cyclic loading or the pressure rating of CIPP liners where passing through bends, which are outside the scope of this document.

It is applicable to cured-in-place pipe lining systems intended to be used at a service temperature of up to 25 °C.

NOTE For applications operating at service temperatures greater than 25 °C guidance on re-rating factors can be supplied by the system supplier.