Stål för värmebehandling
- +Ämnesområden
- +Metallurgi (12)
- Tillverkning av metalliska material (0)
- +Provning av metalliska material (2)
- Korrosion (2)
- +Järn och stål (0)
- Ferrolegeringar (0)
- +Icke-järnmetaller (2)
- +Järn och stålprodukter (6)
- Järn och stålprodukter: allmänt (0)
- Stål för värmebehandling (2)
- Stål för armering av betong (2)
- Specialstål (2)
- Fjäderstål (0)
- Stål för tryckkärl (0)
- Verktygsstål (0)
- Stål med specifika magnetiska egenskaper (0)
- Olegerade stålprodukter (1)
- Platta stålprodukter och halvfabrikat (0)
- Stång och valstråd av stål (0)
- Ståltråd, stållinor, ringkedjor (0)
- Profiler av stål (0)
- Stålrör (2)
- Gjutgods av stål och järn (0)
- Järn-och stålsmide (0)
- Övriga järn och stål produkter (0)
- +Formvaror av icke-järnmetaller (2)
- Pulvermetallurgi (1)
- Utrustning för metallurgisk industri (0)
This document specifies requirements for non-alloy and alloy steels that are intended for cold heading or cold extruding and are delivered as wire rods, wire or bars. It also contains specific requirements
for:
— steels not intended for heat treatment, with diameters from 2 mm to 100 mm (see Annex A);
— case-hardening steels with diameters from 2 mm to 100 mm (see Annex B);
— steels for quenching and tempering, including boron-alloyed steels (see Table C.3), with diameters from 2 mm to 100 mm (see Annex C);
This document (except Annex A) is applicable to the properties of cold-headed or cold-extruded parts which have been subjected to a subsequent heat treatment. As the properties of the parts in the coldheaded
or cold-extruded, and subsequently not-heat-treated condition, are largely dependent on the applied cold-heading or cold-extruding conditions, these are, if necessary, subject to agreement between the purchaser and the manufacturer of the parts.
This document specifies requirements for stainless steels that are intended for cold heading or cold extruding and are delivered as wire rods, wire or bars. It contains specific requirements for steels with diameters of 0,8 mm up to 50 mm for austenitic steels, up to 25 mm for ferritic steels and up to 100 mm for martensitic steels.
This document is applicable to the properties of cold-headed or cold-extruded parts which have been subjected to a subsequent heat treatment. As the properties of the parts in the cold-headed or cold-extruded, and subsequently not-heat-treated condition, are largely dependent on the applied
cold-heading or cold-extruding conditions, these are, if necessary, subject to agreement between the purchaser and the manufacturer of the parts.